pad out

英 [pæd aʊt]

美 [pæd aʊt]

拉长…的篇幅

柯林斯词典

• PHRASAL VERB 拉长…的篇幅
  If youpad outa piece of writing or a speechwithunnecessary words or pieces of information, you include them in it to make it longer and hide the fact that you have not got very much to say.
  1. The reviewer padded out his review with a lengthy biography of the author...
     评论者在他的评论中添加了冗长的作者生平以拉长篇幅。
  2. If I wanted to pad out my sermon a little, I might offer my congregation one of my favourite quotations.
     如果我想把布道时间延长一点儿，可能会给教众引用一段我最喜欢的话。

双语例句

• In practice, however, customers pad out their bill by ordering extras, such as a glass of wine, a slice of tart or a coffee ( or, in my case, all three).
  然而，在实际中，顾客会点杯葡萄酒、一块果馅饼或一杯咖啡等额外的食物（就我而言，我会3个全点），从而拉长他们的账单。
• It mapped special controls to a large plastic pad that could be laid out on the floor of the living room.
  它映射到一个特别管制大型塑料垫可以铺在客厅的地板上。
• The paper introduces the design principle of rubber absorbing pad applied to motor suspending set of locomotive and points out the application properties, various index and applied effects at same time.
  介绍机车电动机橡胶减振垫产品的设计原理，指出产品的使用性能、各项指标及应用效果。
• To make a cold pad, use a towel or cloth that has been dipped in very cold water, wrung out and folded into a pad.
  冷垫可以用毛巾或布料在非常冷的水中浸湿，把水拧干，折叠成垫子。
• Conclusion: Laser therapy has a good effect for patients with knee infra-patellar fat pad lesion, when the rehabilitation exercise carry out at the same time, the therapeutic efficiency can improve significantly and maintain longer.
  结论：半导体激光对髌下脂肪垫炎的治疗疗效良好，若同时进行康复训练，将显著提高并维持疗效。
• After that, through one-time pad method, communicating parties can carry out unconditionally secure communications.
  在这之后，再通过一次一密的方法，通信双方就可以进行无条件安全的通信了。
• You'll have to pad out the chair with some more cloth before recovering it.
  在套上椅罩之前，你须先用些布把椅子垫厚实了。
• Temperature curves in solder-pad interface have been measured in laser soldering process. Theoretical analysis is carried out to the characteristics of overheat degree of interface temperature in the wetting process.
  测量了激光加热钎焊过程中钎料-导体界面的温度变化曲线，并对润湿过程界面温度过热的特征进行了理论分析。
• To validate the mathematical relationship, the rubber pad forming experiment was carried out.
  最后，应用该函数关系对软模成形容框进行了设计和校核。
• You will be responsible for all levels of analog mask layout from floor planning, ESD pad placement, block level layout up to top level integration tape out.
  主要负责所有模拟电路版图的整体布局、静电保护设计和模块到顶层的集成设计和流片。